SIKA TOP SEAL – 107 A 20kg + B 5kg (GREY) *set* WATERPROOFING CEMENT

ITEM INCLUDED : 

SIKA TOP SEAL – 107 A 20kg + B 5kg (GREY) *set*

 

2 part polymer modified cementitious waterproof mortar slurry

Comprising of a liquid polymer and a cement based mix incorporating special admixtures

It is applied to concrete and mortar to prevent water infiltration

 

USES: SikaTop Seal-107 is used for:

Interior and exterior waterproofing and damp-proofing of concrete, cementitious rendering, brickwork and blockwork

Protection of concrete structures against the effects of de-icing salts and freeze-thaw attack

Exterior waterproofing of basement walls in new construction and refurbishment

Pore / blowhole filling

Rigid waterproofing of water tanks, swimming pools, etc.

Sealing fine "hairline" cracks in concrete structures not subject to movement

Sealing internal basement walls against dampness

Leveling mortar for concrete repair works

Potable concrete water tanks

Basements

Terraces and balconies

Retaining walls

Swimming pools and fountains

RC gutters and planter boxes

Bathroom floors

Seawalls

 

CHARACTERISTICS AND ADVANTAGES:

Pre-batched components – mixes and applies easily

Slurry or trowellable consistency

Good adhesion to sound, prepared substrates

Increased frost and salt resistance

Protects against concrete carbonation and water penetration

Non toxic – suitable for contact with drinking water

Non corrosive to steel and iron

 

COLOUR:

Part A: white liquid Part B: Grey powder Part A+B: Grey slurry

 

PACKAGING:

A 20kg + B 5kg 

 

Coverage Depending on type of application, two (2) coats always required. Three (3) coats may be required in areas of extremely high infiltration.

• – 1st coat consumption 1-1.5 kg/m2 on damp surface.
• – 2nd coat consumption 0.8 – 1 kg/m2 approx.

 

Surface Preparation Concrete, mortar and masonry surfaces must be clean, free from grease, oil and loosely adhering particles. All surfaces must be as true and flat as possible. Saturate absorbent surfaces thoroughly with water before application.

 

Application Mixing

 

The consistency of the mix can be altered by reducing the amount of component (A) (liquid) to be used. Under normal circumstances, when the full quantities of both components are mixed together, a slurry consistency will result. For a trowelable consistency use only 90% of component (A) (approx. 4.5 kg) Mix in a clean container by slowly adding the powder component to the liquid component and stirring with slow speed mixer.